Welcome to the Nintendo Power Supply section. We will show you which power supplies work with your classic Nintendo systems. In this section.
NOTE: When it comes to power supplies, the two areas that are of the most concern are VOLTS OUTPUT and AMPS OUTPUT. The VOLTAGE should always be the right amount for the system you are hooking up (most systems list their requirements on the bottom). The AMPS on the other hand you have a little leeway with, you can safely use a power supply that provides MORE amps than the system requires, but not (much) fewer AMPS. So if your system wants .85 amps, it would be OK to use 1.2 amps, as the system can adjust its needs.
NES-002
For use with Nintendo Entertainment System
INPUT: 120V AC 60Hz 17W
OUTPUT: 9V – 1.3 mA
This is the power supply that came with the original NES and NES 2 Top Loader.
MADE FOR:
New Replacement NES-002 Power Supply
Over at the Trog Store we have a great replacement power supply for the NES-002.
High Quality NINTENDO – NES replacement power supply for the NINTENDO NES-002. It also works with the SNES.
SNS-002
For use with Super Nintendo Entertainment System
INPUT: 120V 60Hz 17W
OUTPUT: 10V – 850 mA
This is the power supply that came with the original Super Nintendo Entertainment System (SNES) and SNES Jr.
MADE FOR:
New Replacement SNS-002 Power Supply
Over at the Trog Store we have a great replacement power supply for the SNS-002.
High Quality Super Nintendo replacement power supply for the NINTENDO SNES-002. It also works with the NES.
DMG-003
For use with original Nintendo Game Boy
OUTPUT: 6V 7W
This is the power supply that could be purchased separately for the original Nintendo Game Boy. In addition to allowing you to plug in the wall and play it contains rechargeable batteries. So you could remove the cord that plugs into the wall and carry this guy around as power source for your Game Boy. Unfortunately these rechargeable NiHM Batteries have most likely dies by now and won’t hold a charge, but they are fairly easy to replace.
MADE FOR:
MGB-005
For use with Nintendo Game Boy Pocket & Game Boy Color
INPUT: AC120V 60Hz 3W
OUTPUT: 3V DC 300 mA
This power supply was first released with the Nintendo Game Boy Pocket. When the Game Boy Color came out it used the same power supply. They did change the case to say that it works with the Pocket and the Color, but if your case just says Game Boy Pocket on it, no worries, it will work just fine with the Color.
MADE FOR:
NUS-002
For use with Nintendo 64 System
INPUT: 100V 50/60Hz 45W
OUTPUT: 3.3V – 2.7 mA / 12V – .8 mA
Well this one doesn’t really matter. It’s only going to fit a Nintendo 64.
MADE FOR:
New Replacement NUS-002 Power Supply
Over at the Trog Store we have a great replacement power supply for the NUS-002.
High Quality Nintendo 64 replacement power supply for the NINTENDO NUS-002.
DOL-002
For use with Nintendo Gamecube
INPUT: 120V 60Hz 17W
OUTPUT: 12V – 3.5 mA
This is the power supply that came with the original NINTENDO Gamecube, and that’s all it will ever work with.
MADE FOR:
Check out the latest on the Trog Blog
Flashback: Power Stone – Sega Dreamcast
Power Stone is a classic 3D fighting game developed by Capcom, initially released in arcades in 1999, and then on the Dreamcast console on September 9 of the same year. A PSP version was released later on October 31, 2006. The game is set in the 19th century, where...
